Filter
Top Products
Configuring a Port to Offer a LAT Service
12-2 Configuring and Managing LAT Services
Configuring a Port to Offer a LAT Service
Configuration Parameters
After you attach a device to a port and ensure that the port and device characteristics
match, you need to specify certain configuration parameters to enable all devices as
LAT services.
The following table lists the configuration parameters. In addition to the parameters
listed in the table, you need to configure certain parameters for specific types of
devices as described in the Configuration of Specific Types of Devices As LAT
Services section in this chapter.
For This
Parameter:
Use This Command: And Refer to This
Section and Chapter:
Service groups CHANGE SERVER
SERVICE GROUPS
ENABLED
Changing Access Server
Service Groups in Chapter 6
Authorized
groups
CHANGE PORT
AUTHORIZED GROUPS
ENABLED
Configuring LAT Group
Codes for Interactive Devices
in Chapter 11
Service name CHANGE SERVICE
NAME
CHARACTERISTIC[S]
Assigning a Service Name (in
this chapter)
Port name CHANGE PORT
n
NAME Assigning a Port Name (in this
chapter)
ID string CHANGE SERVICE
NAME
Assigning an Identification
String (in this chapter)
Modem control CHANGE PORT
n
SIGNAL CONTROL
ENABLED
Specifying MODEM
CONTROL and SIGNAL
CONTROL in Chapter 10
Signal control CHANGE PORT
n
MODEM CONTROL
ENABLED
Specifying MODEM
CONTROL and SIGNAL
CONTROL in Chapter 10
Service
Password
CHANGE SERVICE
NAME PASSWORD
WORD
Specifying the Service
Password (in this chapter)