Filter
Top Products
Access Server Commands
2-4 Management Tools
Reference
For more information about this command group and its qualifiers, please refer to the
Network Access Server Command Reference
.
Privileged Commands
To manage and configure the network, you use privileged commands. To enable
privileged commands, use the SET PRIVILEGED command. The command line
interface prompts you to enter the privileged password (which does not appear on the
screen). If you forget the privileged password, you can reset the access server to its
defaults by plugging the unit in while holding the reset button.
More than one port at a time can be privileged. Therefore, you should not reveal the
privileged password.
Example: Enabling Privileged Commands
This example shows how to use the SET PRIVILEGED command to enable privileged
commands on a port after accessing the access server.
Local> SET PRIVILEGED
Password> (not echoed)
Local>
Example: Changing the Privileged Password
To change the password, use the SET SERVER PRIVILEGED PASSWORD
command. The following example shows how to use the SET SERVER PRIVILEGED
PASSWORD command to change the privileged password.
Local> SET SERVER PRIVILEGED PASSWORD
Password> (not echoed)
Verification> (not echoed)
Local>