Initializing the Access Server
5-4 Initializing the Access Server
Initializing the Access Server
Using the INITIALIZE Command
To use the INITIALIZE command, log in to
one
of the following:
• A terminal attached to the access server
• The remote console port
Login Methods
You can use any of the following methods to log into the remote console port:
• NCP
• SET HOST/MOP
• CCR
• Telnet remote console
Refer to Remote Console Port section in Chapter 2 for additional information about the
remote console port.
Default Mode for the INITIALIZE Command
To use the INITIALIZE command in its default mode of operation, enter the
following:
Local> INITIALIZE
In this mode of operation, the following steps occur:
Step Action
1
If the access server has Flash capabilities and the image name stored
in NVRAM matches the image name stored in Flash, the access server
loads the image from Flash RAM.
2
If there is no image in FLASH or the access server lacks FLASH
capabilities, the access server loads the software image from a load
host on the network.