Filter
Top Products
Configuring for SNMP Access 16-7
Configuring the Access Server for SNMP Access
Configuring Community Names to Send TRAP Messages
You can optionally configure the access server to send TRAP messages to a specific
NMS for each community name. The access server generates TRAP messages in
response to the events listed in the following table:
Example: Configuring SNMP TRAP Messages
The following example shows how to create the community name server. In this
example, only NMS 195.1.1.2 can access community name SERVER. The access
server sends TRAP messages to this NMS.
Local> CHANGE SNMP COMMUNITY "SERVER" ADDRESS 195.1.1.2
Local> CHANGE SNMP COMMUNITY "SERVER" SET ENABLED
Local> CHANGE SNMP COMMUNITY "SERVER" TRAP ENABLED
Local> CHANGE SNMP AUTHENTICATION ENABLED
Local> CHANGE SNMP ENABLED
Note
TRAPS cannot be enabled for communities with the IP address ANY.
This Event: Occurs When:
Cold start The access server was reinitialized.
Line up A network data link session was established on port
n
.
Line down A network data link session was disconnected on port
n
.
Authentication Unauthorized SNMP access was attempted.