Filter
Top Products
Displaying PPP Status
19-12 Configuring and Managing Point-to-Point Protocol (PPP) Ports
Displaying PPP Status
Introduction
This section describes how to display the PPP LCP and IPCP status.
Displaying LCP Status
Use the SHOW PORT
n
LCP STATUS command to display LCP characteristics. This
command is nonprivileged. This command shows the actual state of the LCP
implementation on the access server. Because of the nature of PPP negotiations, the
display can differ from the configured characteristics shown on the SHOW PORT
n
PPP LCP CHARACTERISTICS display.
The display fields fall into two categories:
• General link status (LCP Status section)
• Status of the LCP options (LCP Options section)
Example: LCP Status Display
The following example shows the LCP status display for port 5:
Local> SHOW PORT 5 PPP LCP STATUS
Port 5: Server: LAT_08002B26D0E7
LCP Status:
State: Initial
Negotiation Time: 0 00:00:00
Since Open: 0 00:00:00
Failure Reason: None
Authentication: Initial
LCP Options: Local: Remote:
MRU: 1500 1500
Character Map FFFFFFFF FFFFFFFF
Authentication: Disabled Disabled
Link Quality: Disabled Disabled
Magic Number: Disabled Disabled
PF Compress: Disabled Disabled
ACF Compress: Disabled Disabled
FCS Size: 16 Bit 16 Bit
Callback: Disabled Enabled