Filter
Top Products
Configuring and Managing SLIP Ports 15-11
Establishing Terminal Sessions with a PC
Establishing Terminal Sessions with a PC
Prerequisites
Before you can use a PC to establish a terminal session with the access server, you
must:
1
Configure the device and port characteristics as described in Chapter 9.
2
Enter the commands to set up SLIP operating characteristics as shown in the
Example: Configuring a PC As a Terminal and SLIP Host, in this chapter.
3
If you want to authenticate a user, make sure that a terminal emulation program is
installed and running on the PC. The terminal emulation program needs to be
invoked after a connection is established so that the user can respond to prompts
for authentication.
Refer to Managing Dial-Up Access Security with AUTOLINK and AUTOLINK
Authentication in Chapter 22 for more information if you have enabled
AUTOLINK authentication.
Once the terminal emulation program is running and the user is authenticated, the PC
can access hosts on the TCP/IP and LAT networks through the access server by using
the CONNECT command.