Filter
Top Products
Configuring a Dial-In Modem for Use with a SLIP Host
15-10 Configuring and Managing SLIP Ports
Configuring a Dial-In Modem for Use with a SLIP Host
Introduction
Before you perform this procedure, you must configure the device and port
characteristics as described in Chapter 9.
Configuring a Dial-In Modem on Port 6 for Use with a SLIP Host
The following example shows a sample configuration of a port using a dial-in modem
for use with a SLIP host on a full modem control access server:
Local> DEFINE PORT 6 ACCESS LOCAL ALTERNATE SPEED NONE AUTOBAUD
ENABLED
Local> DEFINE PORT 6 DEFAULT PROTOCOL SLIP
Local> DEFINE PORT 6 DSRLOGOUT DISABLED DTRWAIT DISABLED
Local> DEFINE PORT 6 FLOW CONTROL CTS INACTIVITY LOGOUT DISABLED
Local> DEFINE PORT 6 INTERRUPTS DISABLED PASSWORD ENABLED
Local> DEFINE PORT 6 SIGNAL CHECK DISABLED SIGNAL CONTROL ENABLED
Local> DEFINE PORT 6 SLIP ENABLED SPEED 57600 SLIP HOST 195.1.3.1
Local> DEFINE PORT 6 SLIP HOST 195.1.3.1
Local> DEFINE PORT 6 SLIP MTU 800
Local> LOGOUT PORT 6
Local> DEFINE PORT 6 SPEED 51600