Filter
Top Products
Configuring and Managing SLIP Ports 15-9
Configuring a Dedicated SLIP Port
Configuring a Dedicated SLIP Port
Introduction
The dedicated SLIP port allows a single SLIP session.
Before you perform this procedure, you must configure the device and port
characteristics as described in Chapter 9.
Configuring a Device As a Dedicated SLIP Host
The following example shows a sample configuration of a dedicated SLIP port:
Local> DEFINE PORT 4 ACCESS LOCAL AUTOBAUD DISABLED AUTOCONNECT
ENABLED
Local> DEFINE PORT 4 BREAK DISABLED DEDICATED SLIP
Local> DEFINE PORT 4 DEFAULT PROTOCOL SLIP
Local> DEFINE PORT 4 DSRLOGOUT DISABLED DTRWAIT DISABLED
Local> DEFINE PORT 4 FLOW CONTROL CTS INACTIVITY LOGOUT DISABLED
Local> DEFINE PORT 4 INTERRUPTS DISABLED PASSWORD DISABLED
PREFERRED NONE
Local> DEFINE PORT 4 SIGNAL CHECK DISABLED SIGNAL CONTROL ENABLED
Local> DEFINE PORT 4 SLIP ENABLED
Local> DEFINE PORT 4 SLIP HOST 195.1.2.1
Local> DEFINE PORT 4 SLIP MTU 800
Local> LOGOUT PORT 4