Filter
Top Products
Configuring Modem Signals 10-15
Sample Modem Configurations
Sample Modem Configurations
Introduction
This section provides sample modem configurations for access servers that support full
MODEM CONTROL.
Configuring a Dial-In Modem on a Full MODEM CONTROL Server
The following example provides a sample configuration for a dial-in modem operating
at 57600 baud. Note that when the port password characteristic is enabled, you must
have previously defined a server login password (refer to Specifying Passwords in
Chapter 22).
Local> DEFINE PORT 6 ACCESS LOCAL ALTERNATE SPEED NONE AUTOBAUD
ENABLED
Local> DEFINE PORT 6 INACTIVITY LOGOUT ENABLED MODEM CONTROL EN-
ABLED
Local>
Configuring a Dial-In Modem on a MODEM CONTROL Server
The following example provides a sample configuration for a dial-in modem operating
at 9600 baud and configured for the RI-DCD-DSRS-DTR signals. Note that when the
port password characteristic is enabled, you must have previously defined a server
login password (refer to Specifying Passwords in Chapter 22).
Local> DEFINE PORT 6 ACCESS LOCAL AUTOBAUD ENABLED SPEED 9600
Local> DEFINE PORT 6 INACTIVITY LOGOUT ENABLED SIGNAL CONTROL EN-
ABLED
Local> DEFINE PORT 6 PASSWORD ENABLED SIGNAL SELECT RI-DCD-DSRS-
DTR
Local> DEFINE PORT 6 SPEED 9600