Filter
Top Products
Displaying PPP Status
19-16 Configuring and Managing Point-to-Point Protocol (PPP) Ports
Displaying ATCP Status
Use the SHOW PORT
n
PPP ATCP STATUS command to display ATCP status. The
This command shows the actual state of the ATCP implementation in the access
server. Because of the nature of PPP negotiations, this display can differ from the
configured characteristics shown on the SHOW PORT
n
PPP ATCP
CHARACTERISTICS display.
The display fields in fall into two categories:
• General ATCP status over the link (ATCP Status section)
• Status of each ATCP option (ATCP Options section)
Example: ATCP Status Display
The following example shows the ATCP status display on port 5:
Local> SHOW PORT 5 PPP ATCP STATUS
Port 5: Server: LAT_08002B26AA94
ATCP Status:
State: Opened
Negotiation Time: 0 00:00:10
Since Open: 0 00:08:10
Failure Reason: None
ATCP Options: Local: Remote:
Appletalk Address: 401.20 401.12
Routing Protocol: RTMP RTMP
Suppress B_Cast: Disabled Disabled
Compression: Disabled Disabled
Connect Time: Disabled Disabled
Server Info: Disabled Disabled
Default Router: 401.249 0.0
Zone Info: LKG Littleton MA