Filter
Top Products
Management Tools 2-9
Remote Console Port
Example: Using NCP to Connect to an Access Server Remote Console Port from
a Load Host
The following example shows a connection from an OpenVMS DECnet Phase IV load
host to an access server that has the DECnet node name SHRIMP. The maintenance
password is FEDCBA. The login password is the default, ACCESS.
$ MCR NCP
NCP> CONNECT NODE SHRIMP SERVICE PASSWORD FEDCBA
Console connected (press CTRL/D when finished)
# ACCESS (not echoed)
Network Access SW Vx.x for DSxxx-xx BLxx-xx ROM Vx.x-x Uptime: 0
00:16:38
(c) Copyright 1993, Digital Equipment Corporation - All Rights
Reserved
Please type HELP if you need assistance
Enter username> MANAGER
Local>
Use of SET HOST/MOP from a DECnet/OSI OpenVMS Node
MOP enables you to connect to the remote console port from an DECnet/OSI
OpenVMS node that is on the same Ethernet as the access server.
To disconnect from the access server, enter Ctrl/ \. Refer to the appropriate DECnet/
OSI manual for information about how DECnet/OSI interprets passwords on the SET
HOST/MOP command line.