Filter
Top Products
Managing Users
11-40 Configuring and Managing Interactive Devices
Example: Configuring LOCK
The following example shows how to enable LOCK on the access server, while
disabling LOCK on ports 5 through 7:
Local> CHANGE SERVER LOCK ENABLED
Local> CHANGE PORT 5-7 LOCK DISABLED
Since anyone can LOCK any terminal, the LOCK facility can cause inconvenience in
a situation where there are irresponsible users. If a user forgets the LOCK password,
you have to log out the port with the LOGOUT command before the port can be used
again. However, the LOGOUT command disconnects all sessions on that port. In that
case, it may be best to disable LOCK on that port and rely on users to protect their
sessions by disconnecting them when they must leave the terminal unattended.
Displaying Information About the Users
You can use the SHOW/MONITOR USERS command to do the following:
•
Determine which ports are in use at any time.
•
Identify the port users.
•
Display information about active port users.
Example: SHOW USERS Display
The following example shows how to generate a users display. The display contains
one line of information for each port that is logged in to the access server:
Local> SHOW USERS
Port Username Status Service
1 Rich Smith Connected DOCUMENT2
2 Jane Brown Locked TIMESHARING
3 giovanni Local Mode
4 (Remote) Connected PRINTER
5 card Connected SLIP