Filter
Top Products
104
5. Ensure that the TCP/IP and HTTP protocols are configured on the device and are fully functional. This
is required to access the multifunction device's CentreWare Internet Services web pages, which can
be used to configure Server Fax settings from a network-connected workstation.
To verify that the TCP/IP and HTTP protocols are correctly configured, print a Configuration Report as
stated in the Configuration Report topic in the Network Connectivity section of this guide.
To configure TCP/IP, refer to the TCP/IP Configuration topic in the NOS Selection section of this
guide.
6. To enable HTTP, refer to the Enable Internet Services (HTTP) topic in the Network Connectivity
section of this guide.
7. Ensure that the FTP Client and SMB port are enabled on the device. To verify this, print a
Configuration Report as stated in the Configuration Report topic in the Network Connectivity section of
this guide.
To enable SMB, refer to Enabling the SMB Setting at the Device in the Microsoft (NetBIOS over IP)
Networks topic of this guide. To enable FTP, use the same SMB enabling procedure, and simply
choose FTP as the port to enable.
8. Install and configure the Xerox-certified, third party fax server per the fax management software
manufacturer's instructions.
Note: If the fax server will be using TCP/IP to communicate, it is recommended that the server be
assigned a static IP address.