Filter
Top Products
51
NetBIOS over IP Peer to Peer Printing
Before You Start
1. Obtain the Print Driver for your workstation's operating system. Drivers are available on one of the
CD-ROMs that came with your Device. They are also typically available for downloading in self-
extracting Zip file format from the Internet at www.xerox.com.
2. Print a Configuration Report as stated under the Network Connectivity Tab of this guide.
3. On the Configuration Report, verify that "SMB" is enabled. Also, verify that TCP/IP is enabled as
one of the supported protocols. Verify that the workgroup's default name is Workgroup, or a valid,
15 character maximum, workgroup name. Also note the Device's SMB Host Name (which assures
the uniqueness of the Device's name within the Workgroup). To enable "SMB," if required, follow the
procedure stated under the Microsoft (NetBIOS over IP) item of the NOS Selection menu, accessed
from the Network Connectivity Tab of this guide. To modify the name of the Workgroup, or Device's
name (SMB Host name) within the workgroup, use your workstation's Web browser to access the
Internet Services (Web Pages) residing in the Device, as described under the Configure SMB menu
item, under the Internet Services Tab of this guide.
4. Make sure to configure the DNS/WINS Server(s) for NetBIOS name to IP address resolution. Then
provide the Device with the addresses of the Servers as stated in the Configure TCP/IP Settings
procedure of the Internet Services section of this guide.