Filter
Top Products
87
[POP3 Server Port Number]
Enter a value in the range from 1 to 65535. The default is 110.
Note: Do not use the numbers of any other ports.
[POP3 Server Check Interval]
Set the interval for checking the e-mail on the POP3 server.
[POP3 Server Login Name]
Enter the name to log in to the POP3 server and press Save.
[POP3 Server Password]
Enter the same password twice in the [New Password] and [Re-enter Password]. If you do not set
the password, leave it blank and select Save.
[POP3 Password Encryption]
Select On (APOP) to encrypt the password, if desired.
c. Select Save and then press Close.
4. Set the protocol for sending E-mail.
a. From the Connectivity & Network Setup list, select Outgoing/Incoming, then select SMTP Server
Settings, and set the following items for the SMTP server.
[SMTP Server Name/Address]
Enter the SMTP Server Name/IP Address and press Save.
Note:
Enter the address in the format “xxx.xxx.xxx.xxx”. The "xxx" should be a numeric value in the range
from 0 to 255. However, 224 - 255.xxx.xxx.xxx and 127.xxx.xxx.xxx cannot be used.