Filter
Top Products
179
Configure communications between the Accounting server and the device
Refer to the remote Accounting server manufacturer's documentation for the specific procedures to follow
to configure communications between the server and the multifunction device.
The server will contact the device based upon Accounting service parameters set up at the server, such as
the device's IP address and polling frequency.
Required network communications and server settings will be stated by the server's manufacturer.
Sample list of set up requirements for Equitrac's Accounting service
• Enable TCP/IP and HTTP on the multifunction device.
• Set up a static or reserved DHCP IP address for the device.
• Enable TCP/IP port 80 communications at the device.
• Download the Controller Interface for Xerox from the Equitrac™ web site.
• Install the Controller Interface for Xerox at the server.
• Verify that you have purchased a license for the Controller Interface for Xerox, as well as a license for
each device communicating with the server.
• Register each multifunction device at the server (using the device's IP address for identification).