Filter
Top Products
Command Dictionary Add Pin Strobes
FastScan and FlexTest Reference Manual, V8.6_4
2-101
Add Pin Strobes
Tools Supported: FlexTest
Scope: Setup mode
Usage
ADD PIn Strobes strobe_time primary_output_pin... [-Period integer]
Description
Adds strobe time to the primary outputs.
The Add Pin Strobes command adds a strobe time for each test cycle of the
specified primary output pins. Any primary outputs without specified strobe times
use the default strobe time. For nonscan circuits, the default strobe time is the last
timeframe of each test cycle. For scan circuits, FlexTest designates time 1 of each
test cycle as the default strobe time for every primary output. You can change the
default time frame for non-scan operations by using the -Period option.
Arguments
• strobe_time
A required integer that specifies the strobe time for each test cycle. This
number should not be greater than the period set with the Set Test Cycle
command.
• primary_output_pin
A required repeatable string that specifies a list of primary output pins.
• -Period integer
Specifies the number of cycles for the period of each strobe. The default is 1.
This option is only available for non-scan operations.
Examples
The following example adds time 1 as the strobe time of primary output pin
outdata1.
set test cycle 3
add pin strobes 1 outdata1