Filter
Top Products
Command Dictionary Write Faults
FastScan and FlexTest Reference Manual, V8.6_4
2-639
• fault code - A code name indicating the lowest level fault class assigned to
the fault.
• fault site - The pin pathname of the fault site.
You can use the -Hierarchy option to write a hierarchical summary of the selected
faults. The summary identifies the number of faults in each level of hierarchy
whose level does not exceed the specified level number. You can further specify
the hierarchical summary by using the -Min_count option which specifies the
minimum number of faults that must be in a hierarchical level before writing.
You may select to display either collapsed or uncollapsed faults by using the Set
Fault Mode command.
Arguments
• filename
A required string that specifies the name of the file where FastScan is to write
the fault information.
• -Replace
An optional switch that replaces the contents of the file if the filename already
exists.
• -Class class_type
An optional switch and literal pair that specifies the class of faults that you
want to write. The class_type argument can be either a fault class code or a
fault class name. If you do not specify a class_type, the default is to write all
fault classes.
Table 2-2 on page 2-299 lists the valid fault class codes and their associated
fault class names; use either the code or the name when specifying the
class_type argument.
• -Stuck_at 01 | 0 | 1
An optional switch and literal pair that specifies the stuck-at faults that you
want to write. The stuck-at literal choices are as follows:
01 — A literal that writes both the “stuck-at-0” and “stuck-at-1” faults. This
is the default.