Filter
Top Products
Command Dictionary Set Drc Handling
FastScan and FlexTest Reference Manual, V8.6_4
2-471
T22 —If the rules checker traces a scan cell during the application of an
independent shift, it must also trace that cell during the application of its
associated general shift.
T23 —The chain length calculated for an independent shift must be the
same as that calculated for its associated general shift.
• Error
An optional literal that specifies for the tool to both display the error
occurrence message and immediately terminate the rules checking.
If you do not specify the Error, Warning, Note, or Ignore option, then the
handling is either set to the previous handling or set to the Design Rules
Checker default.
• Warning
An optional literal that specifies for the tool to display the warning summary
message indicating the number of violations for that rule. If you also specify
the Verbose option, the tool displays the occurrence message for each
occurrence of the rules violation.
If you do not specify the Error, Warning, Note, or Ignore option, then the
handling is either set to the previous handling or set to the Design Rules
Checker default.
• NOTe
An optional literal that specifies for the tool to display the summary message
indicating the number of violations for that rule. If you also specify the
Verbose option, the tool also displays the occurrence message for each
occurrence of the rules violation
If you do not specify the Error, Warning, Note, or Ignore option, then the
handling is either set to the previous handling or set to the Design Rules
Checker default.
• Ignore
An optional literal that specifies for the tool not to display any message for the
rule’s violations. The tool must still check some rules and they must pass to
allow later performance of certain functions.