Filter
Top Products
FastScan and FlexTest Reference Manual, V8.6_4
2-298
Report Faults Command Dictionary
Report Faults
Tools Supported: FastScan and FlexTest
Scope: Atpg, Fault, and Good modes
Usage
For FastScan
Path Delay Faults Usage:
REPort FAults [-Class class_type] [-
All | object_pathname...]
[-Both | -Rise | -Fall]
Stuck/Toggle/Iddq Faults Usage:
REPort FAults [-Class class_type] [-Stuck_at {
01 | 0 | 1}] [-All |
object_pathname...] [-Hierarchy integer [-Min_count integer]] [-Noeq]
For FlexTest
REPort FAults [-Class class_type] [-Stuck_at {01 | 0 | 1}] [-All |
object_pathname...] [-Hierarchy integer [-Min_count integer]] [-Noeq]
Description
Displays fault information from the current fault list.
The Report Faults command displays faults from the fault list added using the
Add Faults or the Load Faults commands. You can use the optional arguments to
narrow the focus of the report to only specific stuck-at faults that occur on a
specific object in a specific class. If you do not specify any arguments, Report
Faults displays information on all the known faults.
The Report Faults command displays the following three columns of information
for each fault:
• fault value - The fault value may be either 0 (for stuck-at-0) or 1 (for stuck-
at-1).
• fault code - A code name indicating the lowest level fault class assigned to
the fault.
• fault site - The pin pathname of the fault site.