I OUTLINE: LIST OF PINS
S1C33210 FUNCTION PART EPSON B-I-3-5
Table 3.4 List of Pins for Clock Generator
Pin name I/O Pull-up Function
OSC1 I – Low-speed (OSC1) oscillation input (32 kHz crystal oscillator or external clock input)
OSC2 O – Low-speed (OSC1) oscillation output
OSC3 I – High-speed (OSC3) oscillation input (crystal/ceramic oscillator or external clock input)
OSC4 O – High-speed (OSC3) oscillation output
PLLS[1:0] I – PLL set-up pins
PLLS1 PLLS0 fin (fOSC3) fout (fPSCIN)
1 1 10–25MHz 20–50MHz
0 1 10–12.5MHz 40–50MHz
0 0 PLL is not used L
PLLC – – Capasitor connecting pin for PLL
Table 3.5 List of Other Pins
Pin name I/O Pull-up Function
/down
TST I Pull-
down
Test mode input pin
This pin is used for testing this chip. For further details, refer to the S1C33 ASIC Design Guide.
DSIO I/O Pull-up Serial I/O pin for debugging
This pin is used to communicate with the debugging tool S5U1C33000H.
#X2SPD I – Clock doubling mode set-up pin1: CPU clock = bus clock × 1, 0: CPU clock = bus clock × 2
#NMI I Pull-up NMI request input pin
#RESET I Pull-up Initial reset input pin
Note:"#" in the pin names indicates that the signal is low active.
