Filter
Top Products
II CORE BLOCK: CLG (Clock Generator)
S1C33210 FUNCTION PART EPSON B-II-6-7
CLKCHG: CPU operating clock switch (D2) / Power control register (0x40180)
Selects the CPU operating clock.
Write "1": OSC3 clock
Write "0": OSC1 clock
Read: Valid
The OSC3 clock is selected as the CPU operating clock by writing "1" to CLKCHG, and OSC1 is selected by
writing "0". The operating clock can be switched over in this way only when both the high-speed (OSC3) and low-
speed (OSC1) oscillation circuits are on. In addition, writing to CLKCHG is effective only when CLGP[7:0] is set to
"0b10010110". Immediately after the oscillation circuit has started oscillating, wait for the oscillation to stabilize
before switching over the CPU operating clock.
At initial reset, CLKCHG is set to "1" (OSC3 clock).
Note: This control bit is effective only when the low-speed (OSC1) oscillation circuit in the Peripheral
Block is used.
CLKDT1–CLKDT0: CPU operating frequency selection (D[7:6]) / Power control register (0x40180)
Select the CPU operating clock frequency.
Table 6.5 Setting of CPU Operating Clock
CLKDT1 CLKDT0 Division ratio
1 1 fout/8
1 0 fout/4
0 1 fout/2
0 0 fout/1
fout: PLL output
This setting is effective when the CPU is operated using the high-speed (OSC3) clock and has no effect on the low-
speed (OSC1) clock. Writing to CLKDT[1:0] is allowed only when CLGP[7:0] is set to "0b10010110".
At initial reset, CLKDT is set to "0" (fout/1).
8T1ON: High-speed (OSC3) oscillation waiting function (D2) / Clock option register (0x40190)
Sets the function for waiting until the high-speed (OSC3) oscillation stabilizes after SLEEP mode is exited.
Write "1": Off
Write "0": On
Read: Valid
After SLEEP mode is exited, the high-speed (OSC3) oscillation waiting function is effective by writing "1" to
8T1ON. For this function to be used, the waiting time must be set in 8-bit programmable timer 1 to allow it to start
counting before entering SLEEP mode. After SLEEP mode is exited, the OSC3 clock is not supplied to the CPU until
8-bit programmable timer 1 underflows. This function will not work when 8T1ON is set to "0".
The high-speed (OSC3) oscillation waiting function is effective only when SLEEP mode is exited.
Writing to 8T1ON is effective only when CLGP[7:0] is set to "0b10010110".
When writing to 8T1ON, always be sure to write "0" to the reserved bits at address 0x40190.
At initial reset, 8T1ON is set to "1" (Off).
HLT2OP: HALT clock option (D3) / Clock option register (0x40190)
Select a HALT condition (basic mode or HALT2 mode).
Write "1": HALT2 mode
Write "0": Basic mode
Read: Valid
When "1" is written to HLT2OP, the CPU will enter HALT2 mode when the HALT instruction is executed. When
"0" is written, the CPU will enter basic mode.
Writing to HLT2OP is allowed only when CLGP[7:0] is set to "0b10010110".
At initial reset, HLT2OP is set to "0" (basic mode).