Filter
Top Products
Using the Command-Line Interface
10
ProSafe Managed Switch
Command Syntax
A command is one or more words that might be followed by one or more parameters.
Parameters can be required or optional values.
Some commands, such as show network or clear vlan, do not require parameters.
Other commands, such as network parms, require that you supply a value after the
command. You must type the parameter values in a specific order, and optional parameters
follow required parameters. The following example describes the network parms
command syntax:
• network parms is the command name.
• <ipaddr> and <netmask> are parameters and represent required values that you must
enter after you type the command keywords.
IPv6 MLD-Proxy
Commands
Require license Require license Supported Supported Require license
PoE Commands Supported Not Supported Not Supported Not Supported Supported
MVR Commands Supported Supported Supported Not Supported Not Supported
Link Local Protocol Filtering
Commands
Supported Supported Supported Supported Supported
Priority-Based Flow Control
Commands
Not Supported Not Supported Not Supported Not Supported Not Supported
Captive Portal Commands Supported Supported Supported Supported Supported
cos-queue random-detect Supported Supported Supported Supported Supported
no cos-queue
random-detect
Supported Supported Supported Supported Supported
random-detect exponential
weighting-constant
Supported Supported Supported Supported Supported
no random-detect
exponential
weighting-constant
Supported Supported Supported Supported Supported
random-detect
queue-parms
Supported Supported Supported Supported Supported
no random-detect
queue-parms
Supported Supported Supported Supported Supported
Format network parms <ipaddr> <netmask> [gateway]
Command Group or
Command
M5300-28G-POE+
M5300-52G-POE+
M5300-28G
M5300-52G
M5300-28G3
M5300-52G3
M5300-28GF3
GSM7328Sv2
GSM7352Sv2
GSM7228PS
GSM7252PS