Filter
Top Products
IPv6 Multicast Commands
440
ProSafe Managed Switch
show ipv6 mroute
Use this command to show the mroute entries specific for IPv6. (This command is the IPv6
equivalent of the IPv4 show ip mcaste mroute command.)
Format show ipv6 mroute {detail | summary}
Modes
• Privileged EXEC
• User EXEC
If you use the detail parameter, the command displays the following Multicast Route Table
fields:
Source IP
Group IP
Expiry Time
Up Time
RPF Neighbor
Flags
If you use the summary parameter, the command displays the following fields:
Source IP
Group IP
Protocol
Incoming
Interface
Outgoing
Interface List
show ipv6 mroute group
This command displays the multicast configuration settings specific to IPv6 such as flags,
timer settings, incoming and outgoing interfaces, RPF neighboring routers, and expiration
times of all the entries in the multicast mroute table containing the given group IPv6 address
<group-address>.
Format show ipv6 mroute group <group-address> {detail | summary}
Modes
• Privileged EXEC
• User EXEC
Term Definition
The IP address of the multicast data source.
The IP address of the destination of the multicast packet.
The time of expiry of this entry in seconds.
The time elapsed since the entry was created in seconds.
The IP address of the RPF neighbor.
The flags associated with this entry.
Term Definition
The IP address of the multicast data source.
The IP address of the destination of the multicast packet.
The multicast routing protocol by which the entry was created.
The interface on which the packet for the source/group arrives.
The list of outgoing interfaces on which the packet is forwarded.