Filter
Top Products
Switching Commands
161
ProSafe Managed Switch
no ip arp inspection vlan logging
Use this command to disable logging of invalid ARP packets on a list of comma-separated
VLAN ranges.
Format no ip arp inspection vlan vlan-list logging
Mode
ip arp inspection trust
Use this command to configure an interface as trusted for Dynamic ARP Inspection.
Default enabled
Format ip arp inspection trust
Mode
no ip arp inspection trust
Use this command to configure an interface as untrusted for Dynamic ARP Inspection.
Format no ip arp inspection trust
Mode
ip arp inspection limit
Use this command to configure the rate limit and burst interval values for an interface.
Configuring none for the limit means the interface is not rate limited for Dynamic ARP
Inspections.
Note: The user interface will accept a rate limit for a trusted interface, but
the limit will not be enforced unless the interface is configured to be
untrusted.
Global Config
Interface Config
Interface Config
Default 15 pps for rate and 1 second for burst-interval
Format ip arp inspection limit {rate pps [burst interval seconds] | none}
Mode
Interface Config