Filter
Top Products
Management Commands
691
ProSafe Managed Switch
no snmp trap link-status
Use this command to disable link status traps by interface.
Note: This command is valid only when the Link Up/Down Flag is enabled.
snmp trap link-status all
Use this command to enable link status traps for all interfaces.
Note: This command is valid only when the Link Up/Down Flag is enabled.
For more information, see
snmp-server enable traps linkmode on
page 687.
no snmp trap link-status all
Use this command to disable link status traps for all interfaces.
Note: This command is valid only when the Link Up/Down Flag is enabled.
For more information, see
snmp-server enable traps linkmode on
page 687.
show snmpcommunity
Use this command to display SNMP community information. Six communities are supported.
You can add, change, or delete communities. The switch does not have to be reset for
changes to take effect.
Format no snmp trap link-status
Mode
Interface Config
Format snmp trap link-status all
Mode
Global Config
Format no snmp trap link-status all
Mode
Global Config