Filter
Top Products
Switching Commands
44
ProSafe Managed Switch
show port protocol
This command displays the Protocol-Based VLAN information for either the entire system, or
for the indicated group.
Format show port protocol {<groupid> | all}
Mode
show port description
This command displays the port description for every port.
Format show port description <unit/slot/port>
Mode
Interface
Description
Physical Mode
The desired port speed and duplex mode. If auto-negotiation support is selected, then
the duplex mode and speed is set from the auto-negotiation process. Note that the
maximum capability of the port (full duplex -100M) is advertised. Otherwise, this object
determines the port's duplex mode and transmission rate. The factory default is Auto.
Physical Status
The port speed and duplex mode.
Link Status
The Link is up or down.
Link Trap
This object determines whether or not to send a trap when link status changes. The
factory default is enabled.
LACP Mode
LACP is enabled or disabled on this port.
Privileged EXEC
Term Definition
Group Name
The group name of an entry in the Protocol-based VLAN table.
Group ID
The group identifier of the protocol group.
Protocol(s)
The type of protocol(s) for this group.
VLAN
The VLAN associated with this Protocol Group.
Interface(s)
Lists the unit/slot/port interface(s) that are associated with this Protocol Group.
Privileged EXEC
Term Definition
Valid slot and port number separated by forward slashes
Shows the port description configured via the “description” command
Term Definition