Filter
Top Products
Switching Commands
230
ProSafe Managed Switch
Priorities are differentiated by the priority field of the IEEE 802.1Q VLAN header, which
identifies an IEEE 802.1p priority value. In NETGEAR Managed Switch, these priority values
must be mapped to internal class-of-service (CoS) values.
To enable priority-based flow control for a particular CoS value on an interface:
• Ensure that VLAN tagging is enabled on the interface so that the 802.1p priority values
are carried through the network.
• Ensure that 802.1p priority values are mapped to IEEE 802.1Q CoS values.
• Use the datacenter-bridging priority-flow-control mode on command to enable
priority-based flow control on the interface.
• Use the datacenter-bridging priority-flow-control priority command to specify the CoS
values that should be paused ("no-drop") due to greater loss sensitivity. Unless
configured as "no-drop," all CoS priorities are considered nonpausable ("drop") when
priority-based flow control is enabled.
When priority-flow-control is disabled, the interface defaults to the IEEE 802.3x flow control
setting for the interface. When priority-based flow control is enabled, the interface will not
pause any CoS unless there is at least one no-drop priority.
datacenter-bridging
Use this command to go into datacenter-bridging mode.
Format
datacenter-bridging
Mode
priority-flow-control mode
Use this command to enable or disable priority-based flow control on an interface.
Format
priority-flow-control mode [on | off]
Mode
Default
priority-flow-control priority
Use this command to specify the priority group(s) that should be paused when necessary to
prevent dropped frames; i.e., the group to receive priority flow control. This configuration has
no effect on interfaces not enabled for priority flow control.
VLAN tagging must be enabled to carry the 802.1p value through the network. The number of
lossless priorities supported is 2. Additionally, the mapping of class-of-service levels to
802.1p priority values to must be set to one-to-one.
Interface Config
Datacenter-Bridging Config
Disabled
Format
priority-flow-control priority priority-list {drop | no-drop}