NETGEAR GSM7228PS-100NAS Switch User Manual


 
Switching Commands
124
ProSafe Managed Switch
A port-channel (LAG) interface can be either static or dynamic, but not both. All members of a
port channel must participate in the same protocols.) A static port-channel interface does not
require a partner system to be able to aggregate its member ports.
Note: If you configure the maximum number of dynamic port-channels
(LAGs) that your platform supports, additional port-channels that you
configure are automatically static.
addport
This command adds one port to the port-channel (LAG). The interface is a logical
unit/slot/port number or a group ID of a configured port-channel.
Note: Before adding a port to a port-channel, set the physical mode of the
port. For more information, see speed on page 42.
deleteport (Interface Config)
This command deletes the port from the port-channel (LAG). The interface is a logical
unit/slot/port number or a group ID of a configured port-channel.
Format deleteport {<logical unit/slot/port>|lag <lag-group-id>}
Mode
deleteport (Global Config)
This command deletes all configured ports from the port-channel (LAG). The interface is a
logical unit/slot/port number of a configured port-channel. To clear the port channels, see
clear port-channel on page 565
Format deleteport <logical unit/slot/port>
Mode
.
Format addport {<logical unit/slot/port>|lag <lag-group-id>}
Mode
Interface Config
Interface Config
Global Config