Filter
Top Products
Routing Commands
254
ProSafe Managed Switch
The following shows example CLI display output for the command.
(Switch) #show ip brief
Default Time to Live........................... 64
Routing Mode................................... Disabled
Maximum Next Hops.............................. 4
Maximum Routes................................. 6000
ICMP Rate Limit Interval....................... 1000 msec
ICMP Rate Limit Burst Size..................... 100 messages
ICMP Echo Replies.............................. Enabled
ICMP Redirects................................. Enabled
show ip interface
This command displays all pertinent information about the IP interface.
Format show ip interface {<unit/slot/port> | vlan <1-4093> | loopback <0-7>}
Modes
• Privileged EXEC
• User EXEC
Term Definition
Default Time to Live
The computed TTL (Time to Live) of forwarding a packet from the local router to the
final destination.
Routing Mode
Shows whether the routing mode is enabled or disabled.
Maximum Next Hops
The maximum number of next hops the packet can travel.
Maximum Routes
The maximum number of routes the packet can travel.
ICMP Rate Limit
Interval
Shows how often the token bucket is initialized with burst-size tokens.
Burst-interval is from 0 to 2147483647 milliseconds. The default burst-interval is
1000 msec.
ICMP Rate Limit
Burst Size
Shows the number of ICMPv4 error messages that can be sent during one
burst-interval. The range is from 1 to 200 messages. The default value is 100
messages.
ICMP Echo Replies
Shows whether ICMP Echo Replies are enabled or disabled.
ICMP Redirects
Shows whether ICMP Redirects are enabled or disabled.
Term Definition
Routing
Interface Status
Determine the operational status of IPv4 routing Interface. The possible values are Up or
Down.
Primary IP
Address
The primary IP address and subnet masks for the interface. This value appears only if
you configure it.
Secondary IP
Address
One or more secondary IP addresses and subnet masks for the interface. This value
appears only if you configure it.