Filter
Top Products
Switching Commands
153
ProSafe Managed Switch
ip verify binding
Use this command to configure static IP source guard (IPSG) entries.
Format ip verify binding <mac-address> vlan <vlan id> <ip address> interface
<interface id>
Mode
no ip verify binding
Use this command to remove the IPSG static entry from the IPSG database.
Format no ip verify binding <mac-address> vlan <vlan id> <ip address>
interface <interface id>
Mode
ip dhcp snooping limit
Use this command to control the rate at which the DHCP Snooping messages come. The
default rate is 15 pps with a range from 0 to 30 pps. The default burst level is 1 second with a
range of 1 to 15 seconds.
Default
Format ip dhcp snooping limit {rate pps [burst interval seconds]}
Mode
no ip dhcp snooping limit
Use this command to set the rate at which the DHCP Snooping messages come, and the
burst level, to the defaults.
Format no ip dhcp snooping limit
Mode
ip dhcp snooping log-invalid
Use this command to control the logging DHCP messages filtration by the DHCP Snooping
application.
Default
Format ip dhcp snooping log-invalid
Mode
Global Config
Global Config
15 pps for rate limiting and 1 sec for burst interval
Interface Config
Interface Config
disabled
Interface Config