Filter
Top Products
Switching Commands
162
ProSafe Managed Switch
no ip arp inspection limit
Use this command to set the rate limit and burst interval values for an interface to the default
values of 15 pps and 1 second, respectively.
Format no ip arp inspection limit
Mode
ip arp inspection filter
Use this command to configure the ARP ACL used to filter invalid ARP packets on a list of
comma-separated VLAN ranges. If the static keyword is given, packets that do not match a
permit statement are dropped without consulting the DHCP snooping bindings.
Default No ARP ACL is configured on a VLAN
Format ip arp inspection filter acl-name vlan vlan-list [static]
Mode
no ip arp inspection filter
Use this command to unconfigure the ARP ACL used to filter invalid ARP packets on a list of
comma-separated VLAN ranges.
Format no ip arp inspection filter acl-name vlan vlan-list [static]
Mode
arp access-list
Use this command to create an ARP ACL.
Format arp access-list acl-name
Mode
no arp access-list
Use this command to delete a configured ARP ACL.
Format no arp access-list acl-name
Mode
Interface Config
Global Config
Global Config
Global Config
Global Config