Filter
Top Products
Routing Commands
259
ProSafe Managed Switch
source. This is typically used for preventing routing loops. The reject route added in the RTO
is of the type OSPF Inter-Area. Reject routes (routes of REJECT type installed by any
protocol) are not redistributed by OSPF/RIP. Reject routes are supported in both OSPFv2
and OSPFv3.
The following shows example CLI display output for the command.
(Switch) #show ip route
Route Codes: R - RIP Derived, O - OSPF Derived, C - Connected, S - Static
B - BGP Derived, IA - OSPF Inter Area
E1 - OSPF External Type 1, E2 - OSPF External Type 2
N1 - OSPF NSSA External Type 1, N2 - OSPF NSSA External Type 2
C 1.1.1.0/24 [0/1] directly connected, 0/11
C 2.2.2.0/24 [0/1] directly connected, 0/1
C 5.5.5.0/24 [0/1] directly connected, 0/5
S 7.0.0.0/8 [1/0] directly connected, Null0
OIA 10.10.10.0/24 [110/6] via 5.5.5.2, 00h:00m:01s, 0/5
C 11.11.11.0/24 [0/1] directly connected, 0/11
S 12.0.0.0/8 [5/0] directly connected, Null0
S 23.0.0.0/8 [3/0] directly connected, Null0
show ip route ecmp-groups
This command reports all current ECMP groups in the IPv4 routing table. An ECMP group is
a set of two or more next hops used in one or more routes. The groups are numbered
arbitrarily from 1 to n. The output indicates the number of next hops in the group and the
number of routes that use the set of next hops. The output lists the IPv4 address and
outgoing interface of each next hop in each group.
Format show ip route ecmp-groups
Mode
Example
(switch) #show ip route ecmp-groups
ECMP Group 1 with 2 next hops (used by 1 route)
172.20.33.100 on interface 2/33
172.20.34.100 on interface 2/34
ECMP Group 2 with 3 next hops (used by 1 route)
172.20.32.100 on interface 2/32
172.20.33.100 on interface 2/33
172.20.34.100 on interface 2/34
ECMP Group 3 with 4 next hops (used by 1 route)
172.20.31.100 on interface 2/31
172.20.32.100 on interface 2/32
172.20.33.100 on interface 2/33
172.20.34.100 on interface 2/34
Privileged EXEC