Filter
Top Products
Utility Commands
548
ProSafe Managed Switch
If some, but not all, of the flags in that group are enabled, the command displays trapflags
<groupname> <flag-name>.
Format show running-config [all | <scriptname>]
Mode
show running-config interface
This command shows the current configuration on a particular interface. The interface could
be a physical port or a virtual port—like a LAG or VLAN. The output captures how the
configuration differs from the factory default value.
Format
Mode
show sysinfo
This command displays switch information.
Format show sysinfo
Mode
Switch
Description
System Name
System
Location
System Contact
System Object
ID
System Up Time
MIBs Supported
show tech-support
Use this command to display system and configuration information when you contact
technical support. The output of this command combines the output of the following
commands:
• show version
• show sysinfo
Privileged EXEC
show running-config interface {<unit/slot/port>} | VLAN <id> | LAG <id>}
Interface Config
Privileged EXEC
Term Definition
Text used to identify this switch.
Name used to identify the switch. The factory default is blank. To configure the system
name, see snmp-server on page 683.
Text used to identify the location of the switch. The factory default is blank. To configure
the system location, see snmp-server on page 683.
Text used to identify a contact person for this switch. The factory default is blank. To
configure the system location, see snmp-server on page 683.
The base object ID for the switch’s enterprise MIB.
The time in days, hours and minutes since the last switch reboot.
A list of MIBs supported by this agent.