Filter
Top Products
Routing Commands
300
ProSafe Managed Switch
no ip ospf retransmit-interval
This command sets the default OSPF retransmit Interval for the specified interface.
Format no ip ospf retransmit-interval
Mode
ip ospf transmit-delay
This command sets the OSPF Transit Delay for the specified interface. The transmit delay is
specified in seconds. In addition, it sets the estimated number of seconds it takes to transmit
a link state update packet over this interface. Valid values for <seconds> range from 1 to
3600 (1 hour).
Default
Format ip ospf transmit-delay <1-3600>
Mode
no ip ospf transmit-delay
This command sets the default OSPF Transit Delay for the specified interface.
Format no ip ospf transmit-delay
Mode
ip ospf mtu-ignore
This command disables OSPF maximum transmission unit (MTU) mismatch detection. OSPF
Database Description packets specify the size of the largest IP packet that can be sent
without fragmentation on the interface. When a router receives a Database Description
packet, it examines the MTU advertised by the neighbor. By default, if the MTU is larger than
the router can accept, the Database Description packet is rejected and the OSPF adjacency
is not established.
Default
Format ip ospf mtu-ignore
Mode
no ip ospf mtu-ignore
This command enables the OSPF MTU mismatch detection.
Format no ip ospf mtu-ignore
Mode
Interface Config
1
Interface Config
Interface Config
enabled
Interface Config
Interface Config