Filter
Top Products
Stacking Commands
33
ProSafe Managed Switch
Example:
(Switch)#show nsf
Administrative Status.......................... Enable
Operational Status............................. Enable
Last Startup Reason............................ Warm Auto-Restart
Time Since Last Restart........................ 0 days 16 hrs 52 mins 55 secs
Restart In Progress............................ No
Warm Restart Ready............................. Yes
Copy of Running Configuration to Backup Unit:
Status...................................... Stale
Time Since Last Copy........................ 0 days 4 hrs 53 mins 22 secs
Time Until Next Copy........................ 28 seconds
Unit NSF Support
---- -----------
1 Yes
2 Yes
3 Yes
initiate failover
Use this command to force the backup unit to take over as the management unit and perform
a “warm restart” of the stack. On a warm restart, the backup unit becomes the management
unit without clearing its hardware tables (on a cold restart, hardware tables are cleared).
Applications apply checkpointed data from the former management unit. The original
management unit reboots. If the system is not ready for a warm restart, for example because
no backup unit has been elected or one or more members of the stack do not support
nonstop forwarding, the command fails with a warning message. The movemanagement
command also transfers control from the current management unit; however, the hardware is
cleared and all units reinitialize.
Note: Use this command instead of movemanagement if you expect nsf
during management unit changes.
Time Since Last Copy When the running configuration was last copied from the management unit to the
backup unit.
Time Until Next Copy The number of seconds until the running configuration will be copied to the backup
unit. This line only appears when the running configuration on the backup unit is
Stale.
NSF Support (Per Unit
Status Parameters)
Whether a unit supports NSF.
Format initiate failover
Mode Stack Global Config Mode
Term Definition