Filter
Top Products
IPv6 Multicast Commands
447
ProSafe Managed Switch
no ipv6 pim join-prune-interval
Use this command to set the join/prune interval to the default value.
Format no ipv6 pim join-prune-interval
Mode
ipv6 pim rp-address
Use this command to statically configure the RP address for one or more multicast groups.
The parameter <rp-address> is the IP address of the RP. The parameter
<groupaddress> is the group address supported by the RP. The parameter <groupmask>
is the group mask for the group address. The optional keyword override indicates that if
there is a conflict, the RP configured with this command prevails over the RP learned by
BSR.
Default
Format ipv6 pim rp-address <rp-address> <group-address> <group-mask>
[override]
Mode
no ipv6 pim rp-address
Use this command to statically remove the RP address for one or more multicast groups.
Format no ipv6 pim rp-address <rp-address> <group-address> <group-mask>
Mode
ipv6 pim rp-candidate
Use this command to configure the router to advertise itself as a PIM candidate rendezvous
point (RP) to the bootstrap router (BSR).
Default
Format ipv6 pim rp-candidate interface <unit/slot/port> <group-address>
<group-mask>
Mode
Format ipv6 pim join-prune-interval <0-18000>
Mode
Interface Config
Interface Config
0
Global Config
Global Config
None
Global Config