Filter
Top Products
Utility Commands
612
ProSafe Managed Switch
A sample output of the trace message is shown below.
<15> JAN 01 00:21:22 192.168.17.29-1 SIM[181040176]: sim_debug.c(128) 20 % Pkt TX - Intf:
1/0/1(1),
SRC_IP:10.50.50.2, DEST_IP:10.50.50.1, Type:ECHO_REQUEST
<15> JAN 01 00:21:22 192.168.17.29-1 SIM[182813968]: sim_debug.c(82) 21 % Pkt RX - Intf:
1/0/1(1), S
RC_IP:10.50.50.1, DEST_IP:10.50.50.2, Type:ECHO_REPLY
The following parameters are displayed in the trace message:
TX/RX
Intf
SRC_IP
DEST_IP
Type
no debug ping packet
This command disables tracing of ICMP echo requests and responses.
Format no debug ping packet
Mode
debug rip packet
This command turns on tracing of RIP requests and responses. This command takes no
options. The output is directed to the log file.
Default
Format debug rip packet
Mode
A sample output of the trace message is shown below.
<15> JAN 01 00:35:15 192.168.17.29-1 RIP[181783160]: rip_map_debug.c(96) 775 %
Pkt RX on Intf: 1/0/1(1), Src_IP:43.1.1.1 Dest_IP:43.1.1.2
Format debug ping packet
Mode
Privileged EXEC
Parameter Definition
TX refers to a packet transmitted by the device. RX refers to packets received by the
device.
The interface that the packet came in or went out on. Format used is unit/slot/port
(internal interface number). Unit is always shown as 1 for interfaces on a non-stacking
device.
The source IP address in the IP header in the packet.
The destination IP address in the IP header in the packet.
Type determines whether or not the ICMP message is a REQUEST or a RESPONSE.
Privileged EXEC
disabled
Privileged EXEC