NETGEAR GSM7228PS-100NAS Switch User Manual


 
Routing Commands
299
ProSafe Managed Switch
OSPF can operate more efficiently by treating the network as a point-to-point network. For
point-to-point networks, OSPF does not elect a designated router or generate a network link
state advertisement (LSA). Both endpoints of the link must be configured to operate in
point-to-point mode.
Default
Format ip ospf network {broadcast|point-to-point}
Mode
no ip ospf network
Use this command to return the OSPF network type to the default.
Format no ip ospf network
Mode
ip ospf priority
This command sets the OSPF priority for the specified router interface. The priority of the
interface is a priority integer from 0 to 255. A value of 0 indicates that the router is not eligible
to become the designated router on this network.
Default
Format ip ospf priority <0-255>
Mode
no ip ospf priority
This command sets the default OSPF priority for the specified router interface.
Format no ip ospf priority
Mode
ip ospf retransmit-interval
This command sets the OSPF retransmit Interval for the specified interface. The retransmit
interval is specified in seconds. The value for <seconds> is the number of seconds between
link-state advertisement retransmissions for adjacencies belonging to this router interface.
This value is also used when retransmitting database description and link-state request
packets. Valid values range from 0 to 3600 (1 hour).
Default
Format ip ospf retransmit-interval <0-3600>
Mode
broadcast
Interface Config
Interface Config
1, which is the highest router priority
Interface Config
Interface Config
5
Interface Config