Filter
Top Products
Quality of Service (QoS) Commands
505
ProSafe Managed Switch
no ipv6 traffic-filter
This command removes an IPv6 ACL identified by <name> from the interface(s) in a given
direction.
Format no ipv6 traffic-filter <name> {{control-plane|in|out}|vlan <vlan-id>
{in|out}}
Modes
• Global Config
• Interface Config
show ipv6 access-lists
This command displays an IPv6 access list and all of the rules that are defined for the IPv6
ACL. Use the [name] parameter to identify a specific IPv6 ACL to display.
Format show ipv6 access-lists [name]
Mode
Rule Number
Action
Match All
Protocol
Source IP
Address
Source L4 Port
Keyword
Destination IP
Address
Destination L4
Port Keyword
IP DSCP
Flow Label
Log
Assign Queue
Mirror Interface
Redirect
Interface
Time Range
Name
Rule Status
Privileged EXEC
Term Definition
The ordered rule number identifier defined within the IPv6 ACL.
The action associated with each rule. The possible values are Permit or Deny.
Indicates whether this access list applies to every packet. Possible values are True or
False.
The protocol to filter for this rule.
The source IP address for this rule.
The source port for this rule.
The destination IP address for this rule.
The destination port for this rule.
The value specified for IP DSCP.
The value specified for IPv6 Flow Label.
Displays when you enable logging for the rule.
The queue identifier to which packets matching this rule are assigned.
The unit/slot/port to which packets matching this rule are copied.
The unit/slot/port to which packets matching this rule are forwarded.
Displays the name of the time-range if the IPv6 ACL rule has referenced a time range.
Status(Active/Inactive) of the IPv6 ACL rule.