Filter
Top Products
Switching Commands
78
ProSafe Managed Switch
dvlan-tunnel ethertype
This command configures the ether-type for all interfaces. The ether-type may have the
values of 802.1Q, vMAN, or custom. If the ether-type has a value of custom, the optional
value of the custom ether type must be set to a value from 0 to 65535.
Default
Format dvlan-tunnel ethertype {802.1Q | vman | custom} [0-65535]
Mode
mode dot1q-tunnel
This command is used to enable Double VLAN Tunneling on the specified interface.
Default
Format mode dot1q-tunnel
Mode
no mode dot1q-tunnel
This command is used to disable Double VLAN Tunneling on the specified interface. By
default, Double VLAN Tunneling is disabled.
Format no mode dot1q-tunnel
Mode
mode dvlan-tunnel
Use this command to enable Double VLAN Tunneling on the specified interface.
Note: When you use the mode dvlan-tunnel command on an
interface, it becomes a service provider port. Ports that do not have
double VLAN tunneling enabled are customer ports.
vman
Global Config
disabled
Interface Config
Interface Config
Default
disabled
Format mode dvlan-tunnel
Mode
Interface Config