Filter
Top Products
Routing Commands
253
ProSafe Managed Switch
encapsulation
This command configures the link layer encapsulation type for the packet. The encapsulation
type can be ethernet or snap.
Default
Format encapsulation {ethernet | snap}
Mode
Note: Routed frames are always ethernet encapsulated when a frame is
routed to a VLAN.
clear ip route all
This command removes all the route entries learned over the network.
Format clear ip route all
Mode
Protocol
Total
Number of
Routes
clear ip route counters
This command resets to zero the IPv4 routing table counters reported in show ip route
summary. The command resets only the event counters. Counters that report the current
state of the routing table, such as the number of routes of each type, are not reset.
Format clear ip route counters
Mode
show ip brief
This command displays all the summary information of the IP, including the ICMP rate limit
configuration and the global ICMP Redirect configuration.
ethernet
Interface Config
Privileged EXEC
Tells which protocol added the specified route. The possibilities are: local, static, OSPF, or
RIP.
The total number of routes.
Privileged EXEC
Format show ip brief
Modes
• Privileged EXEC
• User EXEC