Filter
Top Products
Switching Commands
165
ProSafe Managed Switch
VLAN DHCP ACL DHCP ACL Bad Src Bad Dest Invalid
Drops Drops Permits Permits MAC MAC IP
----- -------- --------- ----------- --------- ---------- ----------- ---------
10 11 1 65 25 1 1 0
20 1 0 8 2 0 1 1
clear ip arp inspection statistics
Use this command to reset the statistics for Dynamic ARP Inspection on all VLANs.
Default none
Format clear ip arp inspection statistics
Mode
show ip arp inspection interfaces
Use this command to display the Dynamic ARP Inspection configuration on all the
DAI-enabled interfaces. An interface is said to be enabled for DAI if at least one VLAN, that
the interface is a member of, is enabled for DAI. Given a unit/slot/port interface argument, the
command displays the values for that interface whether the interface is enabled for DAI or
not.
Format show ip arp inspection interfaces [unit/slot/port]
Mode
• Privileged EXEC
• User EXEC
Example: The following shows example CLI display output for the command.
(Switch) #show ip arp inspection interfaces
Interface Trust
State Rate Limit Burst Interval
(pps) (seconds)
--------------- ----------- ---------- ---------------
0/1 Untrusted 15 1
0/2 Untrusted 10 10
Privileged EXEC
Term Definition
Interface
The interface ID for each displayed row.
Trust State
Whether the interface is trusted or untrusted for DAI.
Rate Limit
The configured rate limit value in packets per second.
Burst Interval
The configured burst interval value in seconds.