Filter
Top Products
Quality of Service (QoS) Commands
479
ProSafe Managed Switch
DiffServ Policy Commands
Use the DiffServ policy commands to specify traffic conditioning actions, such as policing and
marking, to apply to traffic classes
Use the policy commands to associate a traffic class that you define by using the class
command set with one or more QoS policy attributes. Assign the class/policy association to
an interface to form a service. Specify the policy name when you create the policy.
Each traffic class defines a particular treatment for packets that match the class definition.
You can associate multiple traffic classes with a single policy. When a packet satisfies the
conditions of more than one class, preference is based on the order in which you add the
classes to the policy. The first class you add has the highest precedence.
This set of commands consists of policy creation/deletion, class addition/removal, and
individual policy attributes.
Note: The only way to remove an individual policy attribute from a class
instance within a policy is to remove the class instance and re-add it
to the policy. The values associated with an existing policy attribute
can be changed without removing the class instance.
The CLI command root is policy-map.
assign-queue
This command modifies the queue id to which the associated traffic stream is assigned. The
queueid is an integer from 0 to n-1, where n is the number of egress queues supported by
the device.
Format assign-queue <queueid>
Mode
Incompatibilities
drop
This command specifies that all packets for the associated traffic stream are to be dropped at
ingress.
Format drop
Mode
Incompatibilities
Policy-Class-Map Config
Drop
Policy-Class-Map Config
Assign Queue, Mark (all forms), Mirror, Police, Redirect