Filter
Top Products
IPv6 Commands
431
ProSafe Managed Switch
no nsf [ietf] helper strict-lsa-checking (OSPFv3)
This command allows OSPF to continue as a helpful neighbor in spite of topology changes.
nsf restart-interval (OSPFv3)
This command configures the length of the grace period on the restarting router. The grace
period must be set long enough to allow the restarting router to reestablish all of its
adjacencies and complete a full database exchange with each of its neighbors.
The
ietf parameter is used to distinguish the IETF standard implementation of graceful
restart from other implementations. Since the IETF implementation is not the only one
supported, this parameter is optional. The
seconds parameter represents the number of
seconds that the restarting router asks its neighbors to wait before exiting helper mode. The
restarting router includes the restart interval in its grace LSAs (range 1–1800 seconds).
Default
Format nsf [ietf]
restart-interval seconds
Mode
no [ietf] nsf restart-interval (OSPFv3)
This command reverts the grace period to its default.
DHCPv6 Commands
This section describes the command you use to configure the DHCPv6 server on the system
and to view DHCPv6 information.
service dhcpv6
This command enables DHCPv6 configuration on the router.
Default
Format service dhcpv6
Mode
no service dhcpv6
This command disables DHCPv6 configuration on router.
Format no service dhcpv6
Mode
120s
OSPFv3 Router Configuration mode
disabled
Global Config
Global Config