Filter
Top Products
Quality of Service (QoS) Commands
498
ProSafe Managed Switch
no ip access-list
This command deletes the IP ACL identified by <name> from the system.
Format no ip access-list <name>
Mode
ip access-list rename
This command changes the name of an IP Access Control List (ACL). The <name>
parameter is the names of an existing IP ACL. The <newname> parameter is a
case-sensitive alphanumeric string from 1 to 31 characters uniquely identifying the IP access
list.
This command fails is an IP ACL by the name <newname> already exists.
Format ip access-list rename <name> <newname>
Mode
{deny | permit} (IP ACL)
This command creates a new rule for the current IP access list. Each rule is appended to the
list of configured rules for the list.
Note: The “no” form of this command is not supported, since the rules
within an IP ACL cannot be deleted individually. Rather, the entire IP
ACL must be deleted and re-specified.
Note: An implicit “deny all” IP rule always terminates the access list.
Note: The mirror parameter allows traffic matching this rule to be copied
to the specified <unit/slot/port>, while the redirect parameter
allows traffic matching this rule to be forwarded to the specified
<unit/slot/port>. The assign-queue and redirect
parameters are valid only for a permit rule.
A rule might either deny or permit traffic according to the specified classification fields. At a
minimum, either the every keyword or the protocol, source address, and destination address
values must be specified. The source and destination IP address fields might be specified
using the keyword ‘
any’ to indicate a match on any value in that field. The remaining
Global Config
Global Config