Filter
Top Products
Utility Commands
580
ProSafe Managed Switch
client-identifier
This command specifies the unique identifier for a DHCP client. Unique-identifier is a valid
notation in hexadecimal format. In some systems, such as Microsoft DHCP clients, the client
identifier is required instead of hardware addresses. The unique-identifier is a concatenation
of the media type and the MAC address. For example, the Microsoft client identifier for
Ethernet address c819.2488.f177 is 01c8.1924.88f1.77 where 01 represents the Ethernet
media type. For more information, refer to the “Address Resolution Protocol Parameters”
section of RFC 1700, Assigned Numbers for a list of media type codes.
Default
Format client-identifier <uniqueidentifier>
Mode
no client-identifier
This command deletes the client identifier.
Format no client-identifier
Mode
client-name
This command specifies the name for a DHCP client. Name is a string consisting of standard
ASCII characters.
Default
Format client-name <name>
Mode
no client-name
This command removes the client name.
Format no client-name
Mode
default-router
This command specifies the default router list for a DHCP client. {address1, address2…
address8} are valid IP addresses, each made up of four decimal bytes ranging from 0 to
255. IP address 0.0.0.0 is invalid.
none
DHCP Pool Config
DHCP Pool Config
none
DHCP Pool Config
DHCP Pool Config
Default
none