Filter
Top Products
Switching Commands
141
ProSafe Managed Switch
show monitor session
This command displays the Port monitoring information for a particular mirroring session.
Note: The <session-id> parameter is an integer value used to identify
the session. In the current version of the software, the
<session-id> parameter is always one (1)
Static MAC Filtering
The commands in this section describe how to configure static MAC filtering. Static MAC
filtering allows you to configure destination ports for a static multicast MAC filter irrespective
of the platform.
macfilter
This command adds a static MAC filter entry for the MAC address <macaddr> on the VLAN
<vlanid>. The value of the <macaddr> parameter is a 6-byte hexadecimal number in the
format of b1:b2:b3:b4:b5:b6. The restricted MAC Addresses are: 00:00:00:00:00:00,
01:80:C2:00:00:00 to 01:80:C2:00:00:0F, 01:80:C2:00:00:20 to 01:80:C2:00:00:21, and
FF:FF:FF:FF:FF:FF. The <vlanid> parameter must identify a valid VLAN.
The number of static mac filters supported on the system is different for MAC filters where
source ports are configured and MAC filters where destination ports are configured.
• For unicast MAC address filters and multicast MAC address filters with source port lists,
the maximum number of static MAC filters supported is 20.
Format show monitor session <session-id>
Mode
Privileged EXEC
Term Definition
Session ID
An integer value used to identify the session. Its value can be anything between 1 and
the maximum number of mirroring sessions allowed on the platform.
Admin Mode
Indicates whether the Port Mirroring feature is enabled or disabled for the session
identified with <session-id>. The possible values are Enabled and Disabled.
Probe Port
Probe port (destination port) for the session identified with
<session-id>. If probe port
is not set then this field is blank.
Mirrored Port
The port, which is configured as mirrored port (source port) for the session identified with
<session-id>. If no source port is configured for the session then this field is blank.
Type
Direction in which source port configured for port mirroring. Types are tx for transmitted
packets and rx for receiving packets.