Filter
Top Products
Routing Commands
296
ProSafe Managed Switch
no external-lsdb-limit
This command configures the default external LSDB limit for OSPF.
Format no external-lsdb-limit
Mode
log-adjacency-changes
To enable logging of OSPFv2 neighbor state changes, use this command in router
configuration mode. State changes are logged with INFORMATIONAL severity.
Default
Format
log-adjacency-changes [detail]
Mode
no log-adjacency-changes
Use the no form of the command to disable state change logging.
Format
no log-adjacency-changes [detail]
Mode
ip ospf authentication
This command sets the OSPF Authentication Type and Key for the specified interface. The
value of <type> is either none, simple or encrypt. The <key> is composed of standard
displayable, non-control keystrokes from a Standard 101/102-key keyboard. The
authentication key must be 8 bytes or less if the authentication type is simple. If the type is
encrypt, the key may be up to 16 bytes. If the type is encrypt a <keyid> in the range of 0 and
255 must be specified. Unauthenticated interfaces do not need an authentication key or
authentication key ID. There is no default value for this command.
Format ip ospf authentication {none | {simple <key>} | {encrypt <key>
<keyid>}}
Mode
Router OSPF Config
Adjacency state changes are logged, but without the detail option.
OSPFv2 Router Configuration
Parameter Description
detail (Optional) When this keyword is specified, all adjacency state changes are logged. Otherwise,
OSPF only logs transitions to FULL state and when a backwards transition occurs.
OSPFv2 Router Configuration
Interface Config