Filter
Top Products
Management Commands
718
ProSafe Managed Switch
• Disable the dhcpv6 client protocol on the network port (with the dhcp option).
Format no network ipv6 address {address/prefix-length [eui64] | autoconfig
| dhcp}
Mode
network ipv6 gateway
Use this command to configure IPv6 gateway (default routers) information for the network
port. The gateway address is in IPv6 global or link-local address format.
Format network ipv6 gateway <gateway-address>
Mode
no network ipv6 gateway
Use this command to remove IPv6 gateways on the network port interface.
Format no network ipv6 gateway
Mode
show network ndp
Use this command to display NDP cache information for the network port.
Default
Format show network ndp
Mode
• Privileged EXEC
• User EXEC
IPv6 Address
MAC Address
isRtr
Neighbor
State
Age Updated
The following shows sample CLI display output for the command:
(switch) #show network ndp
Neighbor Age
IPv6 Address MAC Address isRtr State Updated
-------------------------- ----------------- ----- -------- -------
3017::204:76FF:FE73:423A 00:04:76:73:42:3a Reachable 447535
Privileged EXEC
Privileged EXEC
Privileged EXEC
enabled
Term Definition
The IPv6 address of the interface.
The MAC Address used.
Specifies the router flag.
The state of the neighbor cache entry. Possible values are: Reachable, Delay.
The time in seconds that has elapsed since an entry was added to the cache.